Pulling Specifications Max Pull: Up To 24,000 lbs. (Bare Drum) Reel Capacity Diameter: 50″ up to 108″ Reel Capacity Width: 56″ Friction Drive System Drive Roller Housings Center-Mounted Power Unit Main Frame Fully Boxed & Reinforced: “Zero Deflection” Mainframe Boxed and Reinforced Drawbar Replaceable Pintle Eye and Safety Chains 20,000 lbs. Stub Spindle Axle Full Air Brakes w/ ABS Multi-Pocket Vertical Lift Hydraulic Mandrel Racks 2 1/2″ Heat-Treated Reel Mandrel w/ Centering Cones Hydraulically Raised and Lowered Drawbar w/ Load-Locked Cylinder Hydraulically Powered Idler Wheel w/ Solid Rubber Tire and Steer-Go Power Steering Four Bank Hydraulic Control Valve w/ Pressure Relief, Gauge, and Positional Levers Stainless Steel Hydraulic Tubing Power Unit Electric Throttle Activation Micro Switch Energized Electric/Hydraulic Proportional Controllers Closed-loop Hydraulic System Two-speed Final Drive w/ Electric-Activated Shift Open Center Auxiliary Hydraulic System Load-Locked Cylinder Provides Pressure to Reel 2 7/16″ Chrome-Plated Drive Shaft Auxiliary Power Shaft w/ Bayonet Hydraulic Oil Cooler Mounted at the Engine Radiator Air Intake Engine Specifications Yanmar 3TNV88C-DYEM Power Rating: 36.8HP @ 3000 rpm Compression Ignition Cold Weather Block Heater Cylinders: 3 ​HOGG & DAVIS HYDRA 985​